Circle Mat

An accessory installed between the bindings on your snowboard to prevent your back foot from slipping when not secured in the binding, such as when boarding the lift.

This stomp pad is crafted from moulded urethane, which makes it lightweight and easy to handle.

To ensure optimal bonding, confirm that both the board and stomp are at room temperature, and clean all surfaces with rubbing alcohol. When prepared, use a hair dryer set to the highest level to heat the board's surface and the adhesive on the stomp. Immediately after heating, place the stomp in position and press it down firmly. Stand on it without turning - the more weight, the better. Allow the bond to cure at room temperature for 24 hours.