Guide to Applying Grip Tape to a Scooter

Maintain command of your stunt scooter by fitting a fresh sheet of grip tape. While you can complete this task solo, there are several crucial steps involved. Our scooter specialist, Mike, is here to assist you through the procedure:

1. Begin by measuring your deck and the grip tape.
2. Turn the grip tape over to mark your measurements.
3. With a ruler and a sharp knife, cut the grip tape to size.
4. Next, detach the brake, axle, and deck ends.
5. Peel back the top section of the grip tape and position it on the deck.
6. Ensure alignment is precise and commence adhering it to the deck.
7. By using the protective paper, eliminate any air bubbles.
8. Create two small incisions in the grip tape at the deck’s end.
9. Then, trace the grip tape along the deck's edges.
10. With a sharp knife, execute a precise cut along the deck's sides.
11. Progress gently around to the rear of the deck.
12. If necessary, attend to the sharp edges.

Your scooter is now fully gripped!