Scooter Upgrade Kit Basic Edition

Does your scooter require an upgrade? Get a well-crafted custom trick scooter featuring a threadless headset, a single-piece T-bar, a compression system, and two lightweight single clamps!

We've assembled a kit of five parts designed to transform the following threaded scooters into threadless ones, thanks to ICS compression technology. A trick scooter equipped with compression spins significantly better and is simpler to tighten, plus the one-piece bar offers enhanced strength.

The kit includes:
1x District Pro Threadless headset
2x District single clamps (32mm & 35mm)
1x Worx Royal Bar black one-piece T-bar (Alu. 35 mm outer)
1x Worx Royal stunt scooter fork black threadless stunt scooter fork
1x Worx compression kit.
Note: Grips are sold separately; all grips are compatible with this bar.

Scooters compatible with the upgrade kit:

• JD Bug Pro Scooter
• Razor Pro XX Scooter
• Razor Ultra Pro Lo Scooter
• Roces Kook Trick Scooter
• Slamm Rage Urban
• Grit Extremist Scooter
• Micro Bullet Street Pro 2.0 Scooter
• Grit Extremist Pro Scooter
• Madd Flow Scooter
• Micro Trixx scooter
• Razor Black Label 3.0 Scooter
• Razor Pro III Scooter
• Madd VX2 Pro 2012
• Razor Black Label 4.0 Scooter
• Madd VX2 Team Edition 2012
• Micro MX Park scooter

The kit is also appropriate for:

• Slamm Mischief
• K2 Park Pro Scooter
• Shaun White Trick scooter
• Grit Elite Scooter
• Micro MX Pro OPB Scooter
• District V4 Complete scooter
• Lucky Crew Scooter
• Madd MGP Ninja Scooter
• Madd MGP Ninja 2012 Scooter
• Madd Nitro End of Days 2012
• Madd Nitro Extreme Scooter

*Other scooters could also be upgraded
*Handlegrips are not included. You can reuse your existing ones or purchase a new pair (any will fit).
*Necessary tools: Screwdriver, Hammer, Tape measure, Unbrako key, and some mechanical skill ;)
-----------------------------------------------------------------------------------------------------------------------------------
Assembly Instructions:
Basic trick scooter assembly knowledge is required. It is advisable to refer to our guide before you begin, which you can find by reading Assembling a custom scooter here.
Upon receiving the kit, begin by cleaning your old scooter and removing the old headcups housed in the headtube.

1. Use a screwdriver to knock out the old headcups and a hammer to install the new ones. Place a wooden block between the hammer and the headcups to prevent scratching the deck or new headcups.
2. Insert the headset bearings into the new headcups.
3. Measure how far the new stunt scooter fork extends into the bar, starting from the top of the headset to the starnut, already present within the bar.
4. Ensure the compression bolt can engage the starnut and streamline the entire system. If the starnut does not extend far enough up the bar, use a screwdriver to push it deeper. Should the starnut be situated too high within the bar, a replacement starnut is provided for use.
5. Adjust the compression so it spins as desired.